System behavior
Supported link modes
The wireless extender supports mul
ti
cast mode, i.e. it can establish a link between a single
transmi
tt
er and one or more receivers.
Link drop
Likely causes for this might be:
Exceeded Range - bring systems back in to range to re-establish link.
Reset - To re-establish link in case Tx/Rx have been reset, it is necessary to reset both sides
when both systems are
within 30 meters
of each other.
LED behaviors transmi
tt
er
Network LED
Solid -
Link to Rx is established
Very
Slow blinking
-
Searching frequency
Normal
(Slow)
blinking
-
Establishing link
Fast blinking
- During reg
istrati
on or when reaching out of range
Off
-
Not broadcas
ti
ng (no registered devices)
Video LED
Solid -
Video signal is locked
Fast blinking
-
Unsupported video resolu
ti
on input
Off
-
Power down or Video not locked
Power LED
Solid -
Power is applied and the switch is ON
Fast Blinking -
System Error
Off
-
No power supplied (or power switch is o
ff)
