Troubles
hooti
ng
Registra
ti
on fails
Make sure both transmi
tt
er and receiver are powered on.
Make sure the power cable is con
ti
nuous.
Make sure that pairing units are the devices currently powered on.
Bring the transmi
tt
er and receiver closer together but with a minimal distance of 1
meter.
Reduce the amount of solid walls between the transmi
tt
er and receiver.
No Signal on monitor
Make the receiver is powered on.
Make sure the monitor is powered on.
Make sure the receiver is properly connected to the monitor.
Make sure the monitor is set to display video from the right source (HDMI1, HDMI2,
HDMI3 etc.).
Reboot the receiver.
Unplug and then re-plug the HDMI cable between the receiver and the monitor.
Replace the HDMI cable.
No video over the wireless link
Make sure the transmi
tt
er is properly connected to the source.
Make sure the source is powered on.
Unplug and then re-plug the transmi
tt
er to the source.
Abnormal Color or Noise on the monitor
Unplug and then re-plug the HDMI cable between the receiver and the monitor.
Unplug and then re-plug the HDMI cable between the transmi
tt
er and the source.
Bring the transmi
tt
er and receiver closer together but with a minimal distance of 1
meter.
Reduce the amount of solid walls between the transmi
tt
er and receiver.
Power cycle the system.
No Audio
Check the mute and audio volume se
tti
ngs on the monitor.
Check the audio format se
tti
ng on the source is incomp
ati
ble with system. Change
the source to output PCM 2.0, DTS or Dolby Digital.
Make sure the pin #2 on the DIP switch is down.
IR Remote Control Malfunc
ti
ons
Make sure the plas
ti
c cover of the ba
tt
ery was removed.
Make sure the remote control ba
tt
eries are full.
Make sure the IR receiver is connected to the receiver.
Make sure there is a far enough distance between the IR receiver and any
fl
uorescent ligh
ti
ng or radi
ati
on interfering with the IR signals.
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
