3
FOXPRO Jack Daddy Operation Instructions
To avoid personal injury and prevent product damage, read all operating instructions and safety
precautions prior to use. A copy of these instructions can be found online at the following
address:
http://www.gofoxpro.com/manuals/jackdaddy.pdf
Please note that these instructions
may be updated without notice. It’s recommended to periodically check the instructions to be
aware of any changes.
Jack Daddy Requirements
The Jack Daddy is shipped without batteries. The Jack Daddy requires 4 ‘AA’ batteries. We
recommend the use of high-quality rechargeable NiMH batteries for the best overall
performance.
Installing batteries in the Jack Daddy
1.
Access the battery compartment by removing the door on the back of the Jack Daddy.
The door features a knurled thumbscrew for easy access.
2.
After the door has been removed, locate the black plastic battery tray. The tray is
double-sided, providing spaces for 4 ‘AA’ batteries.
3.
Remove the battery tray from the compartment.
4.
Insert the batteries into each battery cavity while observing polarity as indicated.
5.
Place the battery tray back into the compartment
6.
Secure the door back to the Jack Daddy.
Jack Daddy Remote: Requirements
The Jack Daddy Remote contains a single lithium coin cell battery (CR2032). To replace the
battery, follow the instructions below:
WARNING
Before attempting to replace the battery, it is crucial that you understand the risks
of electrostatic discharge potentially harming the electronic board during battery
replacement!
Prior to replacing the battery, make sure that you are static free. You
can touch your hand to a refrigerator door, oven housing, door knob, etc. If you have
the ability to use a proper grounding wrist strap, please do so.
1.
Carefully separate the Jack Daddy Remote into two halves. This can be accomplished
with a flathead screwdriver or other comparable tool.
2.
Locate the battery and carefully remove it from the board by sliding it out of the
holder.
Note battery orientation as you remove it as the new battery must go back
in the same way
.
3.
Carefully slide the new battery into the holder.
Содержание JackDaddy
Страница 1: ......
