18
Chapter 2 Installation Instructions
1394 Header: F_1394 (optional)
The 1394 expansion cable can be connected
to either the front (provided that the front panel
of your chassis is equipped with the appropri-
ate interface) or real panel of the chassis.
Wake-up On LAN: WOL
Through the Wake-Up On LAN function, a wake
event occurring from the network can wake up
the system. To utilize this function, please be
sure to use an ATX 12V power supply with a
5VSB line capable of delivering a current of at
least 1A, and a LAN adapter which supports
this function. Then connect the header to the
relevant connector on the LAN adapter, set
“
MACPME Power Up Control
”
to
“
Enabled
”
in
the
“
Power Management Setup
”
section of the
CMOS SETUP. Save and exit, then boot the op-
erating system once to make sure this function
takes effect.
F_1394
GND
12V
TP B -
GND
TPA -
1
12V
TP B +
GND
Empty
TPA +
WOL
Signal for waking up
GND
1
+5VSB
S-ATA Connectors:
SATA-1, SATA-2
(optional)
The S-ATA header is used to connect the S-
ATA device to the motherboard.
These connectors support the thin Serial ATA
cables for primary internal storage devices.
The current S-ATA interface allows up to
150MB/s data transfer rate.
SATA_1/SATA_2
GND
GND
GND
TX+
TX-
RX+
RX-
1
PDF created with pdfFactory Pro trial version
www.pdffactory.com
