15
Chapter 2 Installation Instructions
Other Connectors
This motherboard includes interfaces for Floppy, IDE HDD, SATA(optional), USB,
1394(optional), IR module, CPU fan, system fan, and others.
FDD Connector: FLOPPY
This motherboard includes a standard FLOPPY interface, supporting 360K, 720K,
1.2M, 1.44M, and 2.88M FDDs.
HDD connectors: PIDE & SIDE
These connectors support the provided UltraDMA133/100/66 IDE hard disk rib-
bon cable. Connect the cable
’
s blue connector to the primary (recommended)
or secondary IDE connector, then connect the gray connector to the Ultra DMA133/
100/66 slave device (hard disk drive) and the black connector to the Ultra DMA133/
100/66 master device. If you install two hard disks, you must configure the
second drive as a slave device by setting its jumper accordingly. Refer to the
hard disk documentation for the jumper settings.
Attention:
Ribbon cables are directional, therefore, make sure to always con-
nect with the cable on the same side as pin 1 of the PIDE/SIDE or
FLOPPY connector on the motherboard.
PDF created with pdfFactory Pro trial version
www.pdffactory.com
