Introduction
13
Alarm
Alarm System Instructions
a. Your bike rack is fitted with a safety alarm which will alert you if the back loses its connection with the vehicle. The alarm
will sound if a suction foot leaks. In the even of this happening the N-Power system will automatically attempt to create a
vacuum seal using the built in pump.
b. The alarm module is fitted with a standard USB which can be connected to your vehicle either via the vehicles own USB, a
USB adaptor or USB port on a sound system. The alarm will connect to the N-Powerbox wirelessly and will alert you in the
even of a pressure error. Double sided toe on the underside of the alarm can be used to hold it in place.
C. PLEASE NOTE: If you are using more than one Fovno bike rack system on your vehicle the alarm system may not operate
correctly due to a shared signal. While the alarm may not operate the N-Power box will still function as normal.
N-Power control box functions
·
Charging: Charging the N-Power box is easy and thanks to the USB C connector you can charge from a phone charger, power
band or a USB charger. Simply remove the waterproof / dust cover and charge with the included USB C wire.
·
The N-Power control box features USB lights that tell you the level of charge in the battery. An orange light indicates the system
needs charging, blue means full and a red lightindicate the system is being charged. To check the battery level press the button
on the N-Power control box.
N-Power Control Box
Dust / water seal
Quick release air hose connection
USB Type C connector
Power button
Battery health check button
(Red light on charge,
blue light on full charge）
（The blue light is normal, and the red
and orange are charged immediately）
red orange blue
blue blue
(Dust cover: When the rack is not in use
please replace the coverto protector
the pneumatic connections.)
The underside of the alarm
A button for the pairing switch
Pairing method of alarm and control box
1. Clear data: There is a small hole on the back of the
alarm that is a button for the pairing switch. After the
alarm is connected to the power supply, press the
switch button in the small hole for about 10 seconds
When the indicator light of the alarm is off, it means
that the original data is cleared.
2. Use the same method to press the switch button
in thes mall hole of the alarm for about 3-5 seconds
After the alarm indicator lights up, start the control
box, and then stop pressing the pairing switch. At
this time, the alarm buzzes tocomplete the pairing.
