Foundry Networks Switch and Router, Руководство по установке и настройке

Страница: 287 / 1070

Configuring Basic Features
December 2000 10 - 29
3. Select the Port link to display the Port table.
4. Click on the Modify button next to the row of information for the port you want to reconfigure.
5. Enter a name in the Name field.
6. Click Apply to save the changes to the device’s running-config file.
7. Select the Save link at the bottom of the dialog. Select Yes when prompted to save the configuration change
to the startup-config file on the device’s flash memory.
Modifying Port Speed
Each of the 10BaseT/100BaseTX ports is designed to auto-sense and auto-negotiate the speed and mode of the
connected device. If the attached device does not support this operation, you can manually enter the port speed
to operate at either 10 Mbps or 100 Mbps. The default value for 10BaseT/100BaseTX ports is 10/100 Auto-sense.
The 100BaseFX ports operate in the full-duplex mode at 100 Mbps only and cannot be modified.
The 1000BaseSX, 1000BaseLX, 1000BaseT, and 1000BaseLH ports operate in the full-duplex mode at one
Gigabit only and cannot be modified.
USING THE CLI
To change the port speed of interface 8 from the default of 10/100 auto-sense to 10 Mbps operating at full-duplex,
enter the following:
BigIron(config)# interface e8
BigIron(config-if-8)# speed-duplex 10-full
Syntax: speed-duplex <value>
The <value> can be one of the following:
• 10-full
• 10-half
• 100-full
• 100-half
• auto
The default is auto.
USING THE WEB MANAGEMENT INTERFACE
To modify port speed:
1. Log on to the device using a valid user name and password for read-write access. The System configuration
panel is displayed.
2. Click on the plus sign next to Configure in the tree view to display the configuration options.
3. Select the Port link to display the Port table.
4. Click on the Modify button next to the row of information for the port you want to reconfigure.
5. Click next to Full Duplex if you want to change the mode to full-duplex only. (This applies only to 10/100
ports.)
6. Click Disable or Enable next to Auto Negotiate to enable or disable auto-negotiation.
7. Click Apply to save the changes to the device’s running-config file.
8. Select the Save link at the bottom of the dialog. Select Yes when prompted to save the configuration change
to the startup-config file on the device’s flash memory.