17
3 Before cleaning the cooktop, ensure that all burners
are turned off and that all components are cool enough
to safely touch.
4 To avoid electrical shock or burns, turn off controls
and ensure the cooktop is cool before cleaning.
5 Do not use harsh or abrasive cleaning detergents,
waxes, polishes, or commercial cooktop cleaners to
clean the cooktop.
6 Use only a sponge, soft cloth, fibrous or plastic brush,
and nylon pad for cleaning.
7 Always dry components completely before using the
cooktop.
8 Control Panel, Door Handle, Control Housing
.
9 Clean the control panel, door handle and control
housing with a solution of mild detergent and warm
water
.
27)
Cleaning
Burner
caps
and
brass
flame
spreaders
1 Check that the burner is turned OFF and allow it to
cool. Lift off the burner cap and brass flame spreader.
Wash them in hot soapy water, rinse, and dry.
2 Use a stiff nylon brush or straight-ended paper clip
to clear the notches of a flame spreader. Replace the
flame spreader and burner cap correctly
.
11.
Troubleshooting Guide
If you can
’
t find an answer to your problem in the chart
below, or if the problem cannot be fixed, you will need
technical help. Contact FOTILE Service Center
.
1) Cooktop
Problem
Probable
C
ause
Solution
Some burners will not
light.Flames do not burn
all around the burner cap.
Burner parts or igniters may
be wet, dirty, or misaligned.
Check that the burner parts are clean,
dry, and correctly assembled. Check
that the igniters are clean and dry.
See ‘Care and cleaning’ for
instructions.
Burner flames very large
and yellow.
Burner bezel ports are
clogged. Burner ports or
burner caps are not
positioned properly. Cook
top is being operated with
the wrong type of gas.
Regulator is not installed, is
faulty, or is set for the wrong
type of gas.
Clean burner bezel ring ports with
straightened paper clip, needle, or
wire. Remove and carefully re- install
burner bezel and caps. Ensure that
the type of cook top matches the
natural gas supply. Check installation,
replace regulator, or set regulator for
proper gas.
10 Do not use abrasive cleaners or scrubbers; they
may permanently damage the finish.
11 Dry the components with a soft, lint-free cloth
.