
7
Specifi cations
Used vacuum tubes
KT88, E88CC, 300B
Maximum output
2,000 mW (at 16 Ω)
Conformity load
impedance
LOW
16 Ω to 600 Ω
HIGH
48 Ω to 600 Ω
Frequency response
20 Hz - 50 kHz (typ)
S/N ratio
115 dB
THD + N characteristics
0.5% or less (32 Ω, 1 V RMS)
Input
RCA (L/R) unbalanced × 1
Output
XLR (4 poles) balanced × 1
6.3 mm in diameter, stereo phones unbalanced × 1
Power supply
AC 120 V/230 V
Power consumption
198 W
Dimensions
430 mm (Width) × 245 mm (Height) × 416 m (Depth) (excluding protrusions)
Unit mass
Approx. 31 kg
* Product specifi cations and appearance are subject to change for improvement without prior notice.
Troubleshooting
The following is a list of frequent problems customers experience and their solutions.
Problems
Solutions
No sound
• Check connections to other devices. (
Ö
page 5)
• Check whether the MAIN SWITCH on the rear panel was turned OFF while the DIRECT INPUT
switch being ON position. After turning the MAIN SWITCH on again, turn the DIRECT INPUT
switch OFF and adjust the sound volume. (
Ö
page 6)
A crackling noise may be heard.
Some smart phones and other transmitting devices used near the unit may cause
interference and noise in amplifi er output. Shutting down transmission by setting a smart
phone to airplane mode may often minimize noise from interference.
A number is displayed after "ER"
appears, then the unit is shut down
and cannot be turned on again.
Note down the number, disconnect the power cord and contact customer support.
"OL" is displayed, the sound volume
drops or the unit is shut down.
This happens when the protective function is triggered after detecting an excessive signal
output in headphone output.
Lower the sound volume and check for short-circuits in cables and jacks.
English
F
rançais
Deutsch