Foster 7334245, Руководство пользователя

Страница: 20 / 124

20
Installing the foam
gasket
(for glass appliances)
Before inserting the appliance into the opening in the kitchen worktop, the supplied foam
gasket must be attached to the lower side of the glass.
Do not install the appliance without the foam gasket!
The gasket should be attached to the appliance in the following way:

Remove the protective film from the gasket.

Attach the gasket to the lower side approximately
A
=2-3 mm from the edge. The gasket
must be attached along the entire length and should not overlap at the corners.

When installing the gasket, make sure that the glass does not come into contact with any
sharp objects.
CONNECTION TO THE POWER SUPPLY

The appliance may
ONLY
be connected by an authorized qualified technician.

Electric system protection should comply with all relevant regulations.

The connection clips can be accessed when the connection clip covers are opened /
removed.

Before connecting the appliance, make sure the voltage indicated on the rating plate is
consistent with the voltage in your home network. Connection voltage should be checked
by a qualified technician using a corresponding measuring device!

The rating plate with basic information is attached on the lower side of the appliance.

In order to make a fixed connection to the mains, insert an all-pole circuit breaker
between the appliance and the mains. This device shall have a contact separation in all
poles, providing full disconnection under overvoltage category III conditions.

The current conducting and isolated parts must be protected from any possibility of direct
contact.

Before any intervention, disconnect the appliance from the power mains. Connect the
appliance in compliance with the electric connections diagram supplied; make sure the
relevant network voltage is observed!

The ground wire should be connected to the clip indicated by the earth symbol.

The mains cable should be fed through the fastening clip which protects it from being
accidentally pulled out.

After connecting the appliance, turn on all cooking zones / heaters for approximately
three minutes to make sure they are operating correctly.

Incorrect connection may destroy parts of the appliance, making the warranty void.

Connection cable on the back of the appliance should be led in such way that it does not
touch the appliance back wall, as this part will get very hot during operation.
Basic adjustment of
sensors to the ambience
Upon each connection to the power supply the sensors of the appliance are automatically
adjusted to the environment to ensure their proper function. All displays turn on and are
fully illuminated for a few seconds.
During the adjustment procedure the sensors must be free of any objects, otherwise the
adjustment procedure will be interrupted until such objects are removed from the sensor
surface. During this period the regulation of the cooktop is impossible.
Installation diagram
The following cables must be used for connection: H05V2V2-F.
LIVE L BROWN
EARTH GREEN / YELLOW
NEUTRAL N BLUE