Fortinet FortiGate 60M, Руководство по установке

Страница: 34 / 64

34
01-28008-0111-20050128 Fortinet Inc.
Using the setup wizard NAT/Route mode installation
To configure DNS server settings
• Set the primary and secondary DNS server IP addresses. Enter
config system dns
set primary <address_ip>
set secondary <address_ip>
end
Example
config system dns
set primary 293.44.75.21
set secondary 293.44.75.22
end
To add a default route
Add a default route to configure where the FortiGate unit sends traffic that should be
sent to an external network (usually the Internet). Adding the default route also
defines which interface is connected to an external network. The default route is not
required if the interface connected to the external network is configured using DHCP
or PPPoE.
• Set the default route to the Default Gateway IP address. Enter:
config router static
edit 1
set dst 0.0.0.0 0.0.0.0
set gateway <gateway_IP>
set device <interface>
end
Example
If the default gateway IP is 204.23.1.2 and this gateway is connected to WAN1:
config router static
edit 1
set dst 0.0.0.0 0.0.0.0
set gateway 204.23.1.2
set device wan1
end
Using the setup wizard
From the web-based manager, you can use the setup wizard to complete the initial
configuration of the FortiGate unit. For information about connecting to the web-based
manager, see
“Connecting to the web-based manager” on page 16 .