Fortinet FortiAPCam-214B, Быстрый старт

Страница: 7 / 28

Page 7
Configuring your Unit
For the camera part of the unit, configuration is done through the
connected FortiRecorder NVR. For details, see the
FortiRecorder
Administration Guide
at http://docs.fortinet.com .
For the access point part, no configuration is required if the unit is directly
connected to the FortiGate or FortiWiFi performing the Wireless LAN
Controller (WLC) functions, or on the same layer-2 network and subnet as
the FortiGate or FortiWiFi unit.
If the FortiAPCam wireless controller’s IP address cannot be determined
using Zero Configuration mode, or if the network uses static IP addresses,
it can be configured to use a static IP address.
To enable the FortiAPCam using Zero Configuration
1.
After connecting the FortiAPCam unit, the unit goes through its boot
procedure and requests an IP address from the DHCP server.
2. If the IP address is retrieved successfully, the FortiAPCam enters
discovery mode to locate a FortiGate or FortiWiFi wireless controller.
The discovery modes are:
• Broadcast
• Multicast
• DHCP option 138
3. Verify that the FortiAPCam has successfully connected to the
controller.