Page 14 / 16
DIAGNOSTICS
DIAGNOSTIQUES
Led Display
Event
Action
1x Red, 1x Green, 1x Blue
Boot Sequence
N/A
Fast Purple Blink
Installer Mode for Validation testing
Cycle ignition OFF to send an Unlock command
Fast Amber Blink
Factory Reset
Restart EVO-START programming
1x Constant Amber Blink
Unable to sync with Digital Remote
starter during EVO-START power-up
Disconnect and Re-connect EVO-START main
harness. Verify Protocol selection.
2x Constant Amber Blink
Validation pending
(make sure that the
EVO-START yellow (+) ignition wire is properly
connected to the vehicle's (+) ignition wire.)
Perform Validation Step:
a. Disconnect the EVO-START unit
b. Cycle ignition to the ON position
c. Re-Connect the EVO-START unit (DO NOT Press
the programming button)
d. The LED will blink Purple rapidly for 15 seconds
e. During this period, Cycle ignition to the OFF
position
f. If the vehicle door’s unlocks, your programming is
successful.
7x Amber Blink
Pit-Stop Mode Not Available
Shutdown and Restart vehicle's engine and
retry Pit-stop mode and/or wrong DATA-LINK
communication port
1x Green Blink
Command sent to Remote starter
succeeded
Remote starter will execute the command sent from
EVO-START unit
1x Amber Blink
Command sent to Remote starter failed
Verify EVO-START protocol selection and/or wrong
DATA-LINK communication port
État de la Del
Évenement
Action
1x Rouge, 1x Verte, 1x
Bleue
Séquence de démarrage
N/A
Clignotement Rapide
Mauve
Mode installateur pour faire la
Validation
Mettre l'ignition a la position OFF pour envoyer
une commande de Déverrouillage
Clignotement Rapide
Ambre
Réinitialisation d’origine
Refaire la programmation du module EVO-
START
1x Clignotement Ambre
Constant
Incapable de syncroniser avec le
démarreur a distance digital durant
la mise sous tension du EVO-START.
Débrancher et Re-brancher le harnais
principal du module EVO-START. Véerifi er la
sélection du protocol
