FORTEZA TRIBO-M, Руководство по эксплуатации

Страница: 17 / 33

JSC “Forteza” “Forteza Tribo ‐ M” operation manual
17
Table 7.1, continued
Type of
maintenance
Operations performed Procedure Norms
2. Seasonal
maintenance
2.1. Proceed to
maintenance No. 1
2.2. Check for delectability Simulate an attempted
penetration over the fence
(mechanical action on the
fence with a force of 8 kg,
minimum, for flexible fences
and 20 kg, minimum, for rigid
ones).
With no alarm signal, strive for
the steady alarm signal
generation under attempted
penetration over the fence. To
this end use the sensitivity
controller to increase the
guard alarm sensitivity
The guard alarm should
go into the “Alarm”
mode and then again
into the “Guard” one
upon every check
action
2.3. Check for noise
immunity
Subject the fence to an action
with a force of 4 kg,
maximum, for flexible fences
and 10 kg, maximum, for rigid
ones.
Less than 1 ‐ s fence stroke with
a wooden stick (branch stroke
simulation).
The guard alarm being
switched to the “Alarm”
mode, use the sensitivity
controller to reduce the guard
alarm sensitivity and proceed
according to Items.2.2 and 2.3
The guard alarm should
not go into the “Alarm”
mode upon every check
action
2.4. Grounding resistance
measurement
Use an ohmmeter to measure
the grounding resistance
R
GR
should not exceed
10 ohm
3. Maintenance
No. 2 (annual)
3.1. Proceed according to
Items 1.1 to 1.3 of the
monthly maintenance
3.2. Check the external
circuits and SPU
terminal blocks for
reliable connection
Remove the SPU cover. Make
sure the wires are reliably
connected to the terminal
blocks. With loose
attachment, tighten the
screws of the terminals. Place
the SPU cover into position
and seal it
External circuit wires
should be reliably
connected to the
terminal blocks in
compliancewith the
connection diagram
3.3. Proceed according to
Item 1.4 of the monthly
maintenance
3.4. Proceed according to
Items 2.2 to 2.4 of the
seasonal maintenance