26
if clogged.
Every 50 working hours, replace the engine oil.
5.3 MACHINE MAINTENANCE
Periodically wash the machine and clean thoroughly
each part. If a high pressure washing system is
used, check that the fuel does not get wet and that
no part is damaged.
After each washing, it is necessary to lubricate all
parts subject to friction.
Once a year inject a little bit of lubricant grease in the
chain drive through the hole that can be seen after
removing the pressure cap (1 fig. 10); such operation
is completed, put the cap.
5.3.1 RECORDING CONTROL LEVER
FORWARD AND REVERSE
To ensure correct operation of the machine and
prevent it from ruining the forward and reverse belts
periodically check the correct tension in the working
position of the same; to do this, you may want to
remove the belt cover (1 Figure 7) and after operating
for a time the two control levers forward and reverse,
check that each of the belts, in working condition,
results extending well in failure to act on the control
cables registers (5 fig. 1) unscrewing a few turns and
secure it by the nut (5 fig. 1).
In the event that one or both straps are damaged,
replace them.
Completed the work remount the cover straps and
secure it with screws.
5.3.2 ADJUSTMENT OF THE ACCELERATOR
CONTROL
Do not change the limits imposed by the manufac
-
turer. In case of necessity carefully follow the direc
-
tives of the engine instruction booklet or contact an
authorized repairer.
5.3.3 BELT REPLACEMENT
To replace the drive belt, use only ORIGINAL belts
and proceed as follows:
- Remove the protection cover by removing the screw
(1 Fig. 7).
- Replace belt (only original belts)
- Adjust the belt tension (see levers Registration)
- Reassemble the protective casing
5.4 EXTRAORDINARY MAINTENANCE
The operations of extraordinary maintenance are
not mentioned in this manual: however, they shall
be performed only by the Manufacturer or by skilled
personnel authorized by the Manufacturer himself.
5.5 SETTING AT REST
In case you foresee a long period of inactivity for the
machine, it is necessary:
- To clean thoroughly all dirt on the machine.
- To check the correct tightening of the screws.
- To check and replace, if necessary, the damaged
or worn parts.
- To coat the ruined or abraded parts with an antitrust
varnish.
- To lubricate/grease all parts subject to wear.
- To cover the machine with a cloth and put it inside,
away from bad weathers, freezing and humidity.
5.6 MACHINE DISMANTLING
In case you decide to dismantle the machine, you
shall separate its components in equal parts which
must be disposed one by one in compliance with the
local regulations concerning waste disposal.
Dispose the exhausted lubricants and the several de
-
tergents, according to their different structure.
ATTENZIONE
For the disposal of the various components, refer
exclusively to legally authorized facilities and can
issue a receipt to disposal.
5.7 SPARE PARTS
The spare parts of the engine unit must be directly
requested to the engine manufacturer or its dealer.
In order to request the spare parts of the machine,
contact the local Dealer of the Manufacturer.
We finally remind you that the Manufacturer is al
-
ways at your disposal in case you need after-sale
service and/or spare parts.
ENGLISH
Содержание F 51
Страница 3: ...3 Fig 2 Fig 3 1 4 3 5 2 Fig 4 750 1200 1380 930 ...
Страница 4: ...4 Fig 5 Fig 6 Fig 7 Fig 8 Fig 9 Fig 10 1 1 1 1 1 2 ...
Страница 5: ...5 Fig 11 1 2 3 4 5 6 ...
