Forster TAP0-EZ1-27, Инструкция по эксплуатации

Страница: 13 / 22

13
Starting Up the Automatic Feeder
Do not put paper or other foreign matter into the powder hopper.
For those models being equipped with a lid protection, check the following:
-- The lid of the powder hopper has to keep the fuse switch pressed.
-- In case the lid should not be mounted properly, the milk powder will not be dispen-
sed.
4.3 Setting the Concentration
The concentration is set by varying the water flow rate.
Take the pressure tube and the water hose out of the mixer.
Hang a cup into the mixer in order to collect the dispensed powder.
Place a measuring cup under the water outlet.
Turn the program switch to
4
and collect the dispensed water into a mea-
suring cup.
After having collected 1 liter of water, immediately turn the program
switch to 0.
The milk powder amount that has been dispensed during the same time represents the milk
powder concentration per liter of water.
When the dispensed milk powder amount is too low, close the water con-
trol valve a little bit.
When the dispensed milk powder amount is too high, open the water
control valve a little bit more.
Remount the pressure tube. The lower end must touch the mixer base.
Hang the water hose into the mixer once again.
4.4 Setting the Temperature
The boiler has to be filled with water!
Turn the heating thermostat so far clockwise until both red marks will
coincide.
Turn the thermostat for minimum operating temperature so far clockwise
until both green marks will coincide.