Canopy
Yoke Cover
Set Screw
and Nut
Set Screw
Clamp
Yoke
Installing the Down Rod
7
Securing Fan to Bracket
Down Rod
Clip Pin
Wood Screw
and Washer
Clamp
Safety Cable
Wood Ceiling Joist
Safety Cable Loop
Hanging Bracket Tab
Hanging Ball Slot
!
WARNING: Failure to align
hanging ball slot with hanging bracket
tab may result in serious personal
injury or death.
1. Remove the Clip (5B)
and Pin (5A) from
your Down Rod (5).
Save the Clip and the
Pin.
4. Thread the wires and
safety cable that
comes from the Motor
assembly through the
Down Rod.
2. Insert the Canopy (6)
and the Yoke Cover
(7) following the
drawing on the right.
Put this assembly
aside.
5. Insert the Down Rod into the Yoke making sure
that the wires are not twisted and aligning the
holes for the pin on the Down Rod with the
holes in the motor Yoke. Insert Pin all the way
through and put the
Clip in place. Secure
tightly the 2 Set Screws
and Nut. Lower Yoke
Cover until it rests
on the Motor
Assembly.
3. Loosen the Set
Screw and Nut and
the Set Screw on
the Yoke. Take the
Clamp out from the
Safety Cable.
1. Using a step ladder lift the fan and using the
opening in the bracket, insert the hanging ball
part of the Down Rod into the bracket and let it
rest there. Gently turn the Down Rod until
you see and feel that the ball slot engages
firmly with the hanging Bracket tab.
2. Find a secure place (preferably a joist) and
using a wood screw and washer (not supplied)
secure the safety cable to it. Adjust the slack of
the safety cable using the clamp. (This step is
NOT required in the US, you can cut the safety
cable or just coil it around the canopy).
