www.forno.nl
5.
outdoor f ire
EST.
2012
3. User manual: ADEZZ
®
built-in burner
- Always make sure the instructions in this user manual are followed exactly. If these instructions are not
followed in the correct way, it may result in a fire or explosion that could cause damage to people,
property or loss of life.
- Never use flammable liquids or vapors in the vicinity of a burning device.
- Improper installation, adjustments or modifications to the equipment can result in injury or property
damage. Read the installation instructions, safety precautions and operating instructions very carefully.
- Do not leave the ADEZZ
®
built-in burner unattended when in use or when connected to an opened gas
bottle.
What to do if the device emits a smell of gas:
- Directly close the bottle and contact a technical gas specialist. Do not use the device until it is approved
for use again.
- Installation, maintenance and service needs to be done by a qualified gas professional in this cases.
- Only use the ADEZZ
®
built-in burner outdoor or in a well-ventilated area. Never use the built-in burner inside
a building, house, garage or any other enclosed area.
- Gas bottles must be placed outdoors and stored in well-ventilated areas. Make sure that gas bottles are
out of reach for children. Gas bottles which are not used or disconnected from the ADEZZ
®
built-in burner
should not be stored in a building, garage or any other enclosed area.
- The ADEZZ
®
built-in burner is best stored in a garage or well-ventilated area. Store the ADEZZ
®
built-in
burner only when it is disconnected from the gas bottle.
- The ADEZZ
®
built-in burner is not approved as a cooking appliance and must not be used as such.
- Check at least every month and every time a change is made to the unit if the ADEZZ
®
built-in burner
has no gas leaks.
- Keep the area around the ADEZZ
®
built-in burner clear of combustible liquids, materials and vapors.
- Never throw anything in the gas fire of the ADEZZ built-in burner.
- Never use a fuel other than propane gas.
Turning on the ADEZZ
®
built-in burner
- Make sure the ADEZZ
®
built-in burner is installed properly and is stable.
- Press the red ignitor until you hear a soft ticking sound (this is the piezo ignition). If you hear nothing when
pressing the ignition button, then you probably need to replace the battery. Hold the control knob pushed
in when you open the gas supply. Turn the control knob to the right for gas supply.
The burner should now ignite within 15 seconds . Keep the control knob pushed in for an additional 15
seconds after the flame has fully ignited. Release the knob and the flame should continue to burn.
If not, repeat the process but hold in the control knob longer after igniting the flame.
Switching off the ADEZZ
®
built-in burner
- Turn the control knob to the left so the flame goes out. If the flame is out, turn off the gas valve on the gas
bottle.
- Let the lava rocks and ceramic logs cool down completely and place the stainless steel cover on the
built-in burner.
FORNO
®
