Maintenance manual | Electro-pneumatic sliding dampers
www.formula-air.com
3
1.
Introduction
This manual cannot be reproduced, even partially, without prior written consent by Formula Air Group. Every step of
the electro-pneumatic sliding damper range has been deeply analyzed by Formula Air Group in the expected area
during the design, construction, and user manual creation. However, it is understood that nothing can replace the
experience, training and good sense of those professionals who work with the device.
Ignoring the cautions and warning from the present user manual, using improperly parts or the whole device supplied,
using unauthorized spare parts, manipulating the device by non-qualified personnel, violation of any safety norm
regarding design, construction and use expected by the supplier, exempt Formula Air Group from all responsibility in
case of damages to people or properties.
Formula Air Group does not take any responsibility for the non-observance of the user about the preventive safety
measures presented in this user manual.
Failure to comply with the requirements of the user manual or incorrect use of the electro-pneumatic sliding damper
during operation can lead to the damage of the electro-pneumatic sliding damper and improper functioning of the
electro-pneumatic sliding damper itself. This will result in termination of the warranty on the item and will release the
manufacturer from any liability.
Warranty
Regarding to the device’s warranty, see the sales general condition.
Attention !
All drawings and references contained within this user manual are non-contractual and are subject to change without
prior notice at the discretion of the Formula Air Group and its partners.
Copyright © Formula Air.
1.1.
How it works
The electro-pneumatic sliding dampers are normally used to shut off or regulate the air flow in duct systems. The
dampers are made of electro-galvanized sheet metal, mounted with PEHD and rubber seals to ensure optimum
tightness.
Note that they are meant to be installed within a complete installation needs to comply to :
2006/42/EU
– Machine Directive
2014/35/EU
– Low Voltage Equipment Directive
2014/30/EU
– Electromagnetic Compatibility and Repealing Directive (EMC)
The electro-pneumatic sliding dampers are designed to control the air flow through the ducting system by sliding a
sheet metal blade.
