Formech IMD508, Инструкция по установке, эксплуатации и обслуживанию

Страница: 10 / 58

Manual - Formech IMD508
10
Installation
The machine should be sited on a level concrete floor. Dusty or draughty areas will compromise machine
performance but it is important to allow enough space (750mm) around the machine to allow access
into the various panels and to ensure a good airflow to prevent overheating. During all of the following
installation ensure that the power supply is properly isolated.
Electrical connection
An electric supply of correct voltage, current & frequency is required. An isolating switch with facility to be
locked in 'OFF' position and capable of handling full current should be wall mounted, within easy reach of
the operator.
Three phase supply
The major current consuming devices within this machine are 230V single phase. However, in order to
balance the load to electricity generator’s requirements, each phase of a standard three-phase supply
should be connected to the L1 L2 & L3 of the machine.
THIS MACHINE MUST BE EARTHED
Pneumatic connection
The connection to the machine should be via a lockable shut off valve.
Ensure that the pneumatic air supply is regulated to 6 BAR or less and is properly filtered & lubricated using
good quality airline oil. A competent person must make compressed air connections
If flexible hoses are used it is strongly advised that they are of Nylon, canvas or wire reinforced rubber and
suitably rated for pressure and temperature. The connection hose size should be 12mm diameter or 1/2”
BSP. The unit is supplied with a length of pipe & BSP fitting.
Maximum airline pressure must not exceed 6 BAR or 80 PSI.
If the air supply is insufficient the performance of the machine will be compromised.
For this reason, an air reservoir should be sited as close to the machine as practical. If this is not possible then
large bore pipes can be used to prevent pressure drop when the above functions are used.
The IMD508 must be installed and commissioned by Formech.
It is essential to read and fully understand all the information in this manual relating to safety
and the Safety Hazards specific to this machine before installing and operating.
Operating procedures for this machine must be assessed, monitored and controlled
by the person responsible for health and safety.