Manual - Formech 450DT V1.0 - 0317
30
Service / Repair
Replacing a Heating Element (continuation)
3. At this stage check that all the element
wires and interconnecting wires are fully
tightened and that the fault was not
merely a loose connection.
4. Remove the relevant terminal
block cover(s).
5. Loosen and remove the element wires
from the appropriate connector block.
6. Remove the nuts and washers holding
the faulty element. Spanner key n°8
7. Remove element and fit the
replacement new heating element
ensuring the fixing screws are secured.
8. Ensure that the connections are
correctly fitted and the connector block
screws are fully tightened. Replace the
connector cover and top heater cover.
Finally test the heater.
