Formax Atlas C150, Руководство по эксплуатации, Страница: 59 / 72

_________________________________________________________________________
59
3
Accuracy Checks
Module Alignment Check
This machine consists of a feeder module and a creaser module. The alignment between
these modules is set at the factory. To check that the modules have not become misaligned
during shipping and handling carry out the following procedure:
1. With the machine powered off open the creaser top cover.
2. Take a stiff sheet of paper [A] and slide it against the registration wall [B].
3. Slide the sheet forwards until it comes in contact with creaser rollers. Check if both
corners [C] of the sheet enter the rollers at the same time. Make sure that during this
check the sheet remains parallel to the registration wall.
4. If the modules are visibly out of alignment, follow the realignment procedure in the
Service Manual.
5. If the modules appear aligned, remove the sheet of paper, close the top cover and
power on the machine.
6. Run a proof sheet with a single crease and inspect the output.
A
B
C