Formax Atlas C150, Руководство по эксплуатации, Страница: 19 / 72

_________________________________________________________________________
19
1
Choose the Correct Blade Set
This machine is supplied with a single standard crease blade set. Several optional blade sets
are available. Refer to the table below to see which type of blade set is most suitable for your
job.
Sheet Thickness Blade Set Crease Width
≥ 0.25 mm
( ≥ 0.010”)
Standard (supplied with machine)
AC-150-20
1.3 mm (0.051”)
≤ 0.25 mm
( ≤ 0.010”)
Narrow (optional)
AC-150-30
1.0 mm (0.039”)
0.09 mm - 0.2 mm
(0.0035” - 0.008”)
Extra Narrow (optional)
AC-150-40
0.7 mm (0.027”)
The Standard blade set is designed to give a good crease on thick paper and thin card. To do
this, it makes a wide crease. A wide crease is necessary because it gives sufficient material
at the spine of the fold.
The Narrow blade set is designed to give a good crease on medium and thin paper. To do this
it makes a narrower crease than the Standard blade set does. A narrower crease is necessary
because if there is too much material at the spine of the fold, the fold might not be accurate or
square.
An Extra Narrow blade set is also available for purchase. The Extra Narrow blade set is
designed to make a very narrow crease. One should use an extra narrow blade set if folding
very thin paper (paper thickness close to the minimum specification for this machine).
Always make sure you have the correct blade set installed before starting a job. When running
into creasing or folding problems, try a different blade set. This can help solve the problem,
even if it is not the usual blade set that is recommended.
Additionally, the crease blade set may be replaced with an optional perforation blade set.
Sheet Thickness Blade Set Perforation
0.09 mm - 0.4 mm
(0.0035” - 0.016”)
Cross-perforation (optional)
AC-150-50
Coarse (7 TPI) or fine (14 TPI)
teeth. Full cross perforation or
partial cross perforation
NOTE:
For blade set replacement instructions, see the “Replacing Blade Sets” section within this
manual.