—
50
—
Tent Camper Owner’s Manual
1. The guide wire will tell you when the roof is ex-
tended to full height. Set the safety supports on the
opposing corner lifter arms.
2. At this time, adjust the awning legs to the desired
height. If you prefer, you can attach the awning legs
to the sockets located on the sidewall. During pe-
riods of high precipitation, adjust the awning pitch
to allow water to run off. It is recommended during
heavy winds that the awning be closed.
3. ltD models only: Now, slide the bunk end out
until it is fully extended. Then, remove the support
poles from under the mattress. Inserting the round
end into the frame, and using your shoulder for le-
verage, raise the bunk and insert the flattened end
into the clip. Locking the bunk into position.
MaC, MaC off road, Classic and high Wall
models: Now, remove the ‘double’ pole bed sup-
ports from under the mattress. The poles with the
black cap are installed in the back of the camper,
and the poles with the white cap are installed in
the front. Install the poles by inserting the clip into
the bracket at the top of the tent camper wall and
into the bracket on the tent camper frame. Place the
bottom pole into the appropriate slot to ensure the
top pole is level. Then slide the bunk end out until
it is fully extended.
If there appears to be an obstruction preventing the
bunks from sliding out, DO NOT proceed until the
source of the interference has been found and cor-
rected. Keep bed slides well lubricated with a type
of clear Silicone spray.
4. Adjust the side bunk tent assembly by securing the
fitted corners and extending the tent sides below
the bunk. Repeat the bunk-end set up procedure on
the other bunk end.
Flagstaff uses water resistant, a 5 piece sectional-
ized tent with down facing interlock seams and is
double stitched at all tension points. see the tent
maintenance section of your owner’s manual for
more information on how to clean and maintain
your tent for years of enjoyment.
5. MaC, MaC off road, Classic and high Wall
models: at this point, if your tent camper is
equipped with Flagstaff’s E-Z Glide slide out di-
nette, there are a few additional steps you will need
to do. Release the slide room by lifting the “lift and
turn” latch, then turning to release the lock.
Содержание 2014 Flagstaff
Страница 1: ...TenT Camper Owner s manual ...
Страница 8: ... 8 Tent Camper Owner s Manual S a m p l e S a m p l e ...
Страница 62: ... 62 Tent Camper Owner s Manual ...