6.
NOTE:
Do not cut the override programming button off of the harness, it is used for all installations.
Review vehicle specific wiring diagram(s) before proceeding.
Connect the following wire to the A-3 Black/White wire in the A connector of the control module
approximately 8 inches from the connector
• A-20 Green/Violet wire in the A connector.
7. Referring to the vehicle specific wiring section for the system being installed, gather all individual
wires that will be routed to the same areas of the vehicle into groups. Cover each wire group with
electrical tape for approximately 18''. Depending on the vehicle, there will be 2 to 5 different wire
groups.
Trim the unused wires approximately 6 - 8'' from the module.
INSTALLATION (Continued)
2013 Fiesta - Push Button Start
Vehicle Security
3
Page 3 of 9
SK9L3Z-19G361-AA
© Copyright Ford 2012 FoMoCo