•
If the indicator light
stays on constantly, programming is complete
and your device should activate when the HomeLink
威
button is pressed
and released.
•
If the indicator light blinks
rapidly for two seconds and then turns
to a constant light continue with “Programming” Steps 4 through
6
to complete programming of a rolling code equipped device (most
commonly a garage door opener).
4. At the garage door opener receiver (motor-head unit) in the garage,
locate the “learn” or “smart” button (usually near where the hanging
antenna wire is attached to the unit).
5. Firmly press and release the “learn” or “smart” button. (The name and
color of the button may vary by manufacturer.)
Note:
There are 30 seconds in which to initiate Step 6.
6. Return to the vehicle and firmly
press, hold for two seconds and
release
the programmed HomeLink
威
button. Repeat the
press/hold/release
sequence again and, depending on the brand of the
garage door opener (or other rolling code equipped device), repeat this
sequence a third time to complete the programming.
HomeLink
威
should now activate your rolling code equipped device. To
program additional HomeLink
威
buttons begin with Step 1 in this section.
For questions or comments, please contact HomeLink
威
at
www.homelink.com
or
1–800–355–3515.
Gate Operator & Canadian Programming
During programming, your
hand-held transmitter may
automatically stop transmitting —
not allowing enough time for
HomeLink
威
to accept the signal
from the hand-held transmitter.
After completing Step 1 outlined in
the
Programming
section, replace
Step 2 with the following:
Note:
If programming a garage door opener or gate operator, it is
advised to unplug the device during the “cycling” process to prevent
overheating.
•
Continue to press and hold the HomeLink
威
button (note Step 2 in the
Programming
section) while you press and release —
every two
seconds
(“cycle”) your hand-held transmitter until the frequency
Driver Controls
110
2011 Edge
(edg)
Owners Guide, 1st Printing
USA
(fus)
