Ford 2008 Explorer, Руководство пользователя

Страница: 561 / 844

3. Firmly press, hold for five seconds and release the programmed
HomeLink
威
button up to two separate times to activate the door. If the
door does not activate, press and hold the just-trained HomeLink
威
button and observe the indicator light.
•
If the indicator light stays on constantly, programming is complete
and your device should activate when the HomeLink
威
button is pressed
and released.
•
If the indicator light blinks rapidly for two seconds and then turns
to a constant light continue with “Programming” Steps 4 through
6
to complete programming of a rolling code equipped device (most
commonly a garage door opener).
4. At the garage door opener receiver (motor-head unit) in the garage,
locate the “learn” or “smart” button (usually near where the hanging
antenna wire is attached to the unit).
5. Firmly press and release the “learn” or “smart” button. (The name and
color of the button may vary by manufacturer.)
Note:
There are 30 seconds in which to initiate Step 6.
6. Return to the vehicle and firmly press, hold for two seconds and
release the HomeLink
威
button. Repeat the press/hold/release
sequence again and, depending on the brand of the garage door opener
(or other rolling code equipped device), repeat this sequence a third
time to complete the programming.
HomeLink
威
should now activate your rolling code equipped device. To
program additional HomeLink
威
buttons begin with Step 1 in the
“Programming” section. For questions or comments, please contact
HomeLink at
www.homelink.com or 1–800–355–3515.
Gate Operator & Canadian Programming
During programming, your
hand-held transmitter may
automatically stop transmitting —
not allowing enough time for
HomeLink
威
to accept the signal
from the hand-held transmitter.
After completing Step 1 outlined in
the
“Programming” section,
replace Step 2 with the following:
Note: If programming a garage door
opener or gate operator, it is advised to unplug the device during the
“cycling” process to prevent overheating.
2008 Explorer (exp)
Owners Guide (post-2002-fmt)
USA
(fus)
Driver Controls
117