Forch 5326 115, Руководство пользователя

Страница: 15 / 64

15
E N G L I S H
14 Check for damaged parts
Before use, carefully check the tool and mains
cable for damage. Check for misalignment and
seizure of moving parts, breakage of parts,
damage to guards and switches and any other
conditions that may affect its operation.
Ensure that the tool will operate properly and
perform its intended function. Do not use the
tool if any part is damaged or defective. Do not
use the tool if the switch does not turn it on
and off. Have any damaged or defective parts
replaced by an authorised FÖRCH repair
agent. Never attempt any repairs yourself.
15 Unplug tool
Switch off and wait for the tool to come to a
complete standstill before leaving it unattended.
Unplug the tool when not in use, before
changing any parts of the tools, accessories or
attachments and before servicing.
16 Avoid unintentional starting
Do not carry the tool with a finger on the
switch. Be sure that the tool is switched off
before plugging in.
17 Do not abuse cord
Never carry the tool by its cord. Never pull the
cord to disconnect from the socket. Keep the
cord away from heat, oil and sharp edges.
18 Store idle tools
When not in use, tools must be stored in a dry
place and locked up securely, out of reach of
children.
19 Maintain tools with care
Keep the tools in good condition and clean for
better and safer performance. Follow the
instructions for maintenance and changing
accessories. Keep all handles and switches
dry, clean and free from oil and grease.
20 Repairs
This tool is in accordance with the relevant
safety regulations. Have your tool repaired by
an authorised FÖRCH repair agent. Repairs
should only be carried out by qualified persons
using original spare parts; otherwise this may
result in considerable danger to the user.
Additional safety rules for grinders
• Your grinder has been designed for grinding
and cutting masonry and steel.
Do not cut or grind light metal with a
magnesium content exceeding 80%
since this type of metal is flammable.
• Do not use any accessories other than fibre
reinforced grinding and cutting discs.
• Use the grinding and cutting discs
recommended by the manufacturer only.
• The max. allowable speed of the grinding
wheel or cutting disc must always be equal to
or greater than the no-load speed of the tool
specified on the nameplate.
• Do not cut workpieces requiring a maximum
depth of cut exceeding that of the cutting disc.
• Do not use grinding and cutting discs that do
not conform to the dimensions stated in the
technical data. Do not use any spacers to
make a disc fit onto the spindle.
• Inspect grinding and cutting discs before each
use. Do not use chipped, cracked or
otherwise defective discs.
• If provided, ensure that blotters are used
when the disc is fitted onto the spindle.
• When applying a threaded hole disc, ensure
that the thread is long enough to accept the
spindle.
• Ensure that the grinding or cutting disc is
mounted correctly before use.
• Let the tool run at no-load in a safe position for
at least 30 seconds. If there is a considerable
vibration or if any other defect occurs, stop
the tool and check it to determine the cause.
• Do not operate this tool without the guard in
place.
• Check that the workpiece is properly
supported.
• Do not operate the tool near flammable liquids,
gases or dust. Sparks or hot chips from
cutting or arcing motor brushes may ignite
combustible materials.
• Do not operate the tool while standing in line
with the disc. Keep other persons away from
the work area.
• Do not use cutting discs for side grinding.
• Do not operate the spindle lock while the tool is
running.
• Beware that after switching off the tool the
wheel continues to rotate for a short period.