ENERGISER TEST continued. Page 12
Step 7: Test Fence Condition
Now that the energiser is turned on, you want to look for one of two conditions on
the front panel LEDs (lights) to know the condition of your fence. Either green LEDs
or the single red LED will flash with each fence pulse.
●
Green LEDs – From 1 to 5 green LEDs will light up with each
high voltage pulse of the energiser. Your fence is in good
condition if you even get 1 green LED. The more LEDs that
light, the higher the voltage at the energiser terminals, and
the better condition your electric fence.
See ‘Output Voltage / Battery Voltage Chart p11 for voltages.
Note:
Your energiser will light more green LEDs in Full-Power
mode than in Half-Power mode.
●
Red LED – If only the red LED lights, with each fence pulse, then the voltage at
the energizer fence terminals is less than 2000V.
You should check all electric fence wire connections and look for fence-line shorts.
An easy way to locate bad fence connections is to walk the fence and listen for
arcs if you don’. You should not hear this snapping sound at the fence connections.
The sound is similar to a static electricity spark when touching a door knob after
walking on carpet. If you do hear this sound, then the connection is not sufficient.
Note:
If you are plugged into mains, via the AC adapter, then the battery test has no
meaning to you. Battery voltage test only has a meaning when connected to
the external 12V battery, via the battery clamp wire assembly.
●
When the unit is ON or OFF, press and hold the “Navi-Button”
to display battery voltage via the front LEDs.
●
After 2 seconds the energizer stops pulsing and displays
either 1-5 green LEDs, or 1 red LED.
These LEDs remain continuously on and remain on until you
release the button.
●
The more green LEDs that light, the more energy that is
remaining in your battery.
●
If only the red LED is shown, then your battery is depleted
and you need to recharge it or swap it.
●
When you are done testing your battery voltage then
release the “Navi-Button” and your energizer returns to
the mode it was originally in.
1
2
3
4
5
HOLD
red
1
2
3
4
5
red
green
Step 8: Test Battery Condition
●
Содержание DUALGIZER DG1
Страница 2: ...Blank page...
