FOR-A UFM-30UDC, Руководство по эксплуатации

Страница: 33 / 38

27
7-4. Scaling menu
Item
Setting
(Default in bold)
Description
Refer
to
ARC mode Normal
Fit to height
Sets automatic scaling mode when inputting
SD-SDI signals.
Normal performs scaling
based on the object width . Fit to height
performs scaling based on the object height .
6
SD in format Normal 4:3
16:9 An
16:9 LB
14:9 LB
13:9 LB
Specifies the aspect ratio when inputting
SD-SDI signals. 6
SD out format Normal 4:3
16:9 An
16:9 LB
14:9 LB
13:9 LB
Specifies the aspect ratio when outputting
SD-SDI signals. 6
Enhance Soft
Normal
Sharp
Selects a level of edge enhancement from three
options. 5-7
Motion sense On
Off
Sets the motion sense filter On/Off.
On : This is effective for images with few
movements. The vertical resolution for the areas
with fewer motions is doubled.
Off : This is effective for images with a lot of
movements. It produces smooth results for
these images.
5-7
Sync mode Enable
Disable
Enable : This allows you to reduce the I/O delay
by bypassing the scaling process, if the input
and output signals are the same format and the
scaling is not needed. It also passes VANC
data.
The scaling is automatically processed and
VANC data is not passed through conversion
even when
Sync mode is set to Enable , if the
input and output formats are different or scaling
is necessary during.
Disable :
This performs scaling and VANC data is not
passed through.
5-7
IMPORTANT
Automatic saving of last setting
The UFM-30UDC automatically holds the last setting applied to it. Therefore, when
you power off the unit,
wait more than 5 seconds after the setting change.
Otherwise, the last setting may not be preserved and not applied to the UFM-30UDC
when you power on the unit again.
IMPORTANT
The 20th line is blanked when the output format is set to 525/59.94i and scaling is
necessary.