FOR-A UFM-30UDC, Руководство по эксплуатации

Страница: 22 / 38

16
5-7. Other Setting

NTSC Setup
Menu Item Setting Description
Input NTSC setup Off Sets the setup level to 0IRE (used in Japan)
when inputting NTSC video signal.
On
Sets the setup level to 7.5IRE (used in USA)
when inputting NTSC video signal.

Video Level (Proc Amp)
Menu Item Setting Description
Input Black level (±100 mV) Adjusts the black level of the input video.
Video level (±6.0dB) Adjusts the video level of the input video.
Chroma level (±6.0dB) Adjusts the chroma level of the input video.

Closed Caption
Menu Item Setting Description
Output Closed
caption SD Enable
Disable
If the CC (Closed Caption) data is included in
the input video, you can select pass (Enable) or
blank(Disable) for the data. The default setting
is pass (Enable).
This setting is only applied to signals at
59.94Hz frame rate, but not to signals at 50Hz
frame rate.

Enhancer
Menu Item Setting Description
Scaling Enhance Soft
Normal
Sharp
Selects enhanced mode among three types.
Change the enhanced mode setting if video
edges look unnatural due to the aspect ratio
conversion. The default setting is
Normal .

Motion Adaptive Filter
Menu Item Setting Description
Scaling Motion
sense Off
On
Sets to On for the images with few movements.
The default setting is On .

Scaling On/Off
Menu Item Setting Description
Scaling Sync mode Enable
Disable
When input and output videos are the same
format and scaling is not needed, set to
Enable . Then you can minimize the process
delay by short-cutting the scaling process.
The default setting is Enable .
If the scaling is needed during conversion, the
scaling is processed regardless of this setting.
If the scaling is needed during conversion and
the 525/59.94i signals are output, the 20th line
of the output signals is blank.
IMPORTANT
The UFM-30UDC automatically holds the last setting applied to it. Therefore, when
you power off the unit,
wait more than 5 seconds after the setting change.
Otherwise, the last setting may not be preserved and not applied to the UFM-30UDC
when you power on the unit again.