FOR-A UFM-30MUX, Руководство по эксплуатации

Страница: 35 / 42

35
9. Troubleshooting
If any of the following problems occur while operating your UFM-30MUX, proceed as indicated
below to see if the problem can be corrected before assuming a unit malfunction has occurred.
Problem Check Action
Cannot operate
the front panel
switches. Is the OPERATE/LOCK switch on the front
panel set to LOCK ?
Set the switch to
OPERATE .
No video
displayed. <SDI signal connection
＞
Is an SDI signal present?
No SIG or CRC ERR is displayed under
[Status - SDI ERR]
(See section 6-6-1.)
Verify the physical SDI
connection.
<SDI signal format>
Is the SDI input format supported?
UNKNOWN is displayed under [Status -
Format].
(See section 6-6-2.)
Input a supported SDI
signal.
(See section 6-5-3. "TV
SYSTEM" for details on
supported TV
standards.)
<SDI signal format>
Are the [System - Format] setting (see section
6-5-3) and the SDI input format different?
Set [System - SDI Lock]
to
Auto .
(See section 6-5-2.)
Or, set [System -
Format] to the SDI input
format.
(See section 6-5-3.)
Cannot map audio
channels.
Is [System - SDI BYPS (SDI BYPASS)] set to
Bypass ?
(See section 6-5-1.)
Set to Operate .
Is [System - MIN DLY (MINIMUM DELAY)] set
to
ON ?
(See section 6-5-4.)
Set to OFF .
Is [Output - EMB THRU] set to Through ?
(See section 6-3-1.)
Set to Embed .
Cannot map audio
per channel. Is an audio channel asynchronous?
"
a " is displayed under [Status - SDI Sync]
(See section 6-6-4.)
"
a " is displayed under [Status - AES Sync]
(See section 6-6-8.)
Group audio mapping
is automatically
performed if an
asynchronous audio
channel is included in a
group.
Strange or noisy
sound output (SDI) Are asynchronous or non-PCM audio forcibly
assigned per channel?
(See sections 6-1-1 to 6-1-3.) Assign audio per group
if an asynchronous or
non-PCM audio
channel is included in a
group.
Cannot output
(embed) the
AES7/8 audio
input.
Is the AES/LTC switch on the front panel set to
LTC ?
Set the switch to AES .
Cannot output
(embed) the LTC
signal, which is
input from AES7/8.
Is the AES/LTC switch on the front panel set to
AES ?
Set the switch to LTC .
Is [LTC- LTC MUX] set to Through ?
(See section 6-4-1.)
Set to MUX .
USO
RESTRITO