82
No. Symptom
Remedial action
14. While reading or
writing to an LTO
tape cartridge, the
tape automatically
ejects and
immediately inserts
itself into the drive.
While reading or writing to an LTO tape cartridge, the tape
cartridge may automatically eject and immediately reinsert itself
into the drive, due to the presence of small dust particles or other
reasons and is
not
an error but a normal process.
In such case, tape writing will still be correctly performed using the
disk cache, even if it requires more time.
15. If the system has shut
down or the power has
been turned off while
an LTO tape is still in
the LTO drive
(1) Turn on the power of the LTR recorder.
(2) The light in the SCD comes on as described below:
1.
The light comes on, and the number “8” is drawn.
2.
The number “8” is displayed.
3. After 1. and 2. are repeated for a short while, the number
displayed as “8” counts down, and eventually “0” is
displayed.
4. The light goes off, and nothing is displayed in the SCD.
5. Now press the [FORCE EJECT] button to unload the LTO
tape.
Attention
: It may take up to 10 minutes to reach the stage
where nothing is displayed on the SCD in step 4.
(3) If the problem cannot be remedied, contact the FOR-A Service
Center.
16
When the front panel
buttons cannot be
operated
When the front panel buttons cannot be operated, the power-off
process for shutdown will not be executed even if the front panel
[Power] button is pressed. In such case such case, check that the
bottom LED of the two LEDs under the front panel [Power] button is
not blinking, and unplug the power cord on the rear panel.
If the problem is not remedied after restarting the unit, contact the
FOR-A Service Center.
17
Cannot eject LTO
tape from drive.
(1) Verify that the LTO tape is mounted. If not, mount the LTO tape.
(See section 2-4-1
. “Inserting and Mounting a Tape Cartridge.”)
(2)
Select “Eject LTO tape” in the LTO Operations screen to eject the
tape. (See section 2-4-2
. “Unloading an LTO Tape Cartridge.”)
(3) If the tape cannot be ejected, execute a
“Force unmount LTO tape”
procedure in the LTO Driver Maintenance Menu Screen (see
section 4-10-1).
(4) If the LTO tape still cannot be ejected, press and hold down the
FORCE EJECT
button. When the SCD display is turned on,
release the button and wait until the LTO tape is ejected from the
drive.
(5) If the problem cannot be remedied, contact your FOR-A reseller.
18.
“6” or “7” is displayed
in the SCD (next to
the LTO drive).
Re-mount the tape.
An error code (6 or 7) displayed while recording indicates that
recorded video has been incorrectly written to the LTO tape and
stored in the internal hard disk drive, and is displayed in blue in the
file list. The recorded video can be written to another LTO tape.
Refer
to “Appendix A “SCD Error Codes” for details on SCD errors.
19. Cannot read MXF
files in another
system.
If an MXF file created in the device cannot be read in an NLE or
other system, set
Embed DMS-1 Metadata in MXF file
to
OFF
in
section 4-7-1
. “Recording Settings #1” before recording and reload
a new MXF file.
