FOR-A HVS-AUX16, Руководство по эксплуатации

Страница: 34 / 51

34
I N 0 1
PGM 1
PGM 2
PREV 1
PREV 2
CLEAN 1
CLEAN 2
SHIFT
HVS-AUX32
AUXILIARY UNIT
POWER CONT A A A A
POWER
CONT
6-3. TAKE Mode
TAKE mode will help you to avoid accidental signal selection. About bus assignments, see "
section 5-3 "Free Assign".

Output signal is switched when SHIFT is pressed after a signal selection.
SHIFT should be flashing after a signal selection button is pressed. During flashing press
SHIFT. SHIFT will automatically turn off if SHIFT is not pressed for 5 seconds during
selection.
If you want to verify the selected signal, set "NAME" for the "DISP" item in the Setup menu.

Shifted buttons cannot be used for the signal selection.
Only top labels of the signal selection buttons are available.
You may change signal assignments for these buttons using free assign function. (See
section 5-3. "Free Assign.")
6-4. Bus Quick Select
The Quick Select mode allows the user to select a bus to control without opening the Setup
menu. In addition, selectable buses can be set up for Quick Select mode. (See section 6-4-1.
"Setting Quick Select.")

Switching to Quick Select Mode
1) Press and hold down the menu control for two seconds to enter the Setup menu.
2) The "OUT?" item will appear in the menu display. Press the menu control.
3) Turn the menu control counter-clockwise to display "QIK."
4) Press the menu control to confirm the setting.
5) Press SHIFT to display EXIT then press menu control to exit menu setup.

Changing the Control Bus in Quick Select Mode
The operational example below shows how to change the control bus from AUX1 to AUX2.
1) The following display shows the signal name (IN01 in the following figure example)
currently selected in AUX1.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32
2) Turn menu control to display AX02.
Two seconds later, the display changes from AUX bus to Signal and the AUX unit starts to
control AUX2.
A X 0 2
POWER
CONT
USO
RESTRITO