The Device Setup window will open. To set the net parameters, select the Network option.
1.- Activate/deactivate the DHCP setting.
With the DHCP option deactivated, it is possible to set:
2.
The IP address on the
AIP-4010
transmitter.
3.
The Netmask from the
AIP-4010
transmitter.
4.
The gateway from the
AIP-4010
transmitter.
To set the input and relay connector parameters, select the I/O option.
5.- For selecting the state of the relays in standby if they
are normally open (Norm. open) or normally closed
(Norm. closed).
6.
For selecting the active sensors through short-circuit
(Closed cir.), or active through open circuit (Open cir.).
To upgrade and restart the equipment, select the Options tag.
7.- For upgrading the AIP-4010 audio transmitter
firmware. For more information, see the Firmware
Upgrading section in this instruction manual.
8.
For restarting the equipment.
- 6 -
EN
AIP-4010_MANUAL_(EN)_20170529_Maquetación 1 29/5/17 9:38 Página 6
