Fomei TR-X 32, Руководство пользователя

Страница: 7 / 14

c) PC sync socket can also be s et as output. Long press the „CH/OK“ button of transmitter until
„Fn“ is displayed on the panel. Then set the value of C.Fn- 03 to „ou“ and the PC sync socket is
under output mode.
Setting the transmitter:
•
Power switch – slide the power switch to „ON“ and the device is on and the indicating light
will not blink.
•
Power switch of AF assist beam – slide the power switch to „ON“ and the AF Lighting is allowed
to output.
•
Channel setting
- 1. Short press the „CH/OK“ button until the channel amount blinks.
- 2. Tu rn the select dial to choose the appropriate channel. Press the „CH/OK“ button
again to confirm the setting.
- 3. This flash trigger contains 32 channels which can be changed from 1 to 32. set the
transmitter and the receiver to the same channel before usage.
•
Mode setting
- 1. Short press the „MODE“ button and the mode of the current group will change.
- 2. The current group’s mode will be changed by the order of TTL/M/-- modes („ -- „
means „OFF“ and the current group will not fire a flash in this mode)
•
Current group setting
- 1. Short press the „GR“ button to set the current group.
- 2. The current group settings will blink and turn the select dial to change the settings.
- 3. When the current group is in the „M“ mode, the power output value is changeable
from 1/1 (full power) to 1/128 (minimal power).
- 4. Short press the „GR“ button again to confirm the settings.
•
Multi flash group ON/OFF settings
- 1. Open the multi flash in the C.Fn custom functions (set C.Fn- 04 as „on“) .
- 2. Short press „MODE“ button to change the m ode of selected group.
- 3. The current group’s mode will be changed simultaneously by the order of on/ -- (--
means „OFF“ which means that the current group will not fire flashes in this mode).
•
Multi flash parameter setting
- 1. Enter into multi flash mode before setting.
- 2. Long press the „MODE“ button to enter multi flash parameter setting menu.
- 3. Then, (output value), „T“ (flash times) and „H“ (flash frequency) will be displayed on
the LCD panel.
- 4. Short press the „GR“ button to choose the settings. Tur n the select dial to change
the blinking setting amount. Continue to press the „GR“ button until all the amounts
are set. Then short press the „MODE“ button to exit.
•
Group settings
- 1. Long press the „GR“ button to set all effective groups simultaneously.
- 2. The settings of all effective groups will blink. Turn the select dial to change the
settings, until one of the group’s settings turns to the maximum or the minimum and
all settings of the effective groups will not change now.
- 3. If the current group is in the „M“ mode, the power output value is changeable from
1/1 (full power) to 1/128 (minimal power) in 0,3 stop increments, until one of the
group’s setting turns to the maximum (1/1) or the minimum (1/128) . If the current