Follett Tempo UCD100A30-CF, Руководство по эксплуатации и обслуживанию

Страница: 11 / 44

Tempo Undercounter Ice Machine Bin 11
Leveling Information
Installation Tip
Note: If the room floor is higher than the floor in the cutout opening,
adjust the rear legs to achieve a total unit rear height of 1/10"
(2.54 mm) less than the opening’s rear height. Shorten the unit
height in the front by adjusting the front legs. This allows the
unit to be gently tipped into the opening. Readjust the front legs
to level the unit after it is correctly positioned in the opening.
1. Use a level to confirm the unit is level. Level should be placed along
top edge and side edge as shown
Fig. 10
1
2. If the unit is not level, adjust the legs on the corners of the unit as
necessary.
NOTE: To meet sanitary requirements in some areas, units are supplied
with gliders so that unit can be removed easily for cleaning and
will have minimal adjustment.
3. Confirm the unit is level after each adjustment and repeat the
previous steps until the unit is level.
Fig. 11
Turn to Adjust
Set in Place
1. Plug in the power/electrical cord.
2. Gently push the unit into position. Be careful not to entangle the
cord or water and drain lines, if applicable.
3. Re-check the leveling from front to back and side to side. Make
any necessary adjustments. The unit’s top surface should be
approximately 1/8" (3 mm) below the countertop.
4. Install the anti-tip bracket.
5. Remove interior packing material and wipe out the inside of the unit
with a clean, water-dampened cloth.
6. Clean the unit prior to first use (see the Cleaning section that
follows).