1" (25mm)
ice tube
retaining
bracket
ice tube
ice tube
Installing to VU155 or VU300 series ice and beverage dispensers
Mount evaporator unit
Note:
Locate unit within 20 ft (6.1m) of dispenser.
1.
Level
unit.
2. Securely attach base of unit using holes found in base plate.
Note:
Do
NOT
weld or permanently attach evaporator unit.
Removal may be necessary for service.
3. Remove front panel of evaporator unit.
Routing and mounting ice transport tubes (Fig. 4).
Incorrect ice transport tube installation can result in wet ice
and dispensing problems. Follow guidelines below to
ensure correct installation. Call factory for assistance if you
are unable to meet these requirements.
Note:
If connecting an MC825 evaporator unit to a manually filled
VU155 or VU300 series dispenser consult dispenser
manual for proper transport tube mounting in dispenser
manual or contact Follett technical service.
1. Push one end of the supplied ice transport tube(s) through
hole(s) provided in side of dispenser.
2. Route tube into ice tube bracket inside dispenser and engage
bracket tabs in holes located in end of ice transport tube(s)
(Fig.
5).
Fig. 4
Correct installation
Incorrect installation
N
o dips,
N
o joints,
N
o
b
ends of
less than
6" (153mm)
Fig. 5 –
Ice tube retainer bracket
7
