20
FOLEYCO.COM
Installing the Filters
IMPORTANT
To prevent engine damage, always operate the engine with the complete foam and
paper air cleaner assembly installed.
1. Carefully slide the foam pre-filter onto the paper filter.
2. Place the air cleaner assembly onto the air cleaner base.
3. Install the cover and secure it with the cover nut.
4. Install the air cleaner cover and secure with the knob.
IMPORTANT
To prevent compressor damage, always operate the Compressor with the complete
paper air cleaner assembly installed.
1. Place the air cleaner assembly onto the air cleaner base.
2. Install the air cleaner cover and secure with the knob.
Air filter
1. Place the air cleaner assembly onto the air filter.
2. Install the air filter cover and secure by rotating to lock into place.
Checking the Engine-Oil Level
Service Interval: Before each use or daily (Check the oil when the engine is cold.)
The engine is shipped with oil in the crankcase; however, check the oil level before and after the engine is first started.
Use high-quality engine oil as described in Engine Oil Specification.
IMPORTANT
Do not overfill the crankcase with oil because this may cause engine damage. Do not
run the engine with oil below the low mark because the engine may be damaged as a result.
Note:
The best time to check the engine oil is when the engine is cool before it has been started for the day. If
it has already been run, allow the oil to drain back down to the sump for at least 10 minutes before checking.
1. Park the machine on a level surface, shut off the engine, verify brake is engaged, and remove the key.
2. Clean around the oil dipstick so dirt cannot fall into the filler hole and damage the engine.
3. Remove the dipstick, wipe it clean, and install until it is fully seated.
4. Remove the dipstick and check the oil level. The oil level should be between the “F” full and “L” low marks
on the dipstick.
5. If the oil level is below the “L” low mark, remove the filler tube cap and add the specified oil until the level
reaches the “F” full mark on the dipstick.
6. Install the oil fill cap and dipstick.
