8
FOLEYCO.COM
TANK, PROBE AND INJECT PRESSURE
The tank pressure is the pressure in the air tank. The probe and inject pressures can be adjusted using the regulators.
SYSTEM CUTOFF SWITCH AND KEY
This is located on the right side of the machine just above the beam. Removing this key will disconnect the
battery from the control. Use this when doing service or when storing the machine for longer periods.
IGNITION SWITCH AND KEY
Use the ignition switch to start and shut off the engine. The switch has 3 positions:
•
START—rotate key clockwise to the START position to engage the starter motor.
•
RUN—when the engine starts, release the key and it moves automatically to the ON position.
(Turn the key to this position to activate the screen and control system)
•
OFF—rotate the key counterclockwise to the OFF position to shut off the engine and control.
THROTTLE LEVER
Use the throttle lever to control the engine speed. Moving throttle lever back increases engine speed (FAST
position); moving it forward decreases engine speed (SLOW position). The engine speed regulates the speed
of the compressor and maximum ground speed of the machine.
TRIGGER SWITCH
When in the injection mode, pushing both trigger switches at the same time will start the inject cycle.
FUEL CAP
Remove to add fuel. See adding fuel section of this manual.
BEAM LOCK
Engage the beam lock to lock the beam in the up position.
NEUTRAL LEVEL
Rotate to put the transmission into neutral. Note: this does not disengage the brake, to you need to move the
handle off the brake position.
NEUTRAL LEVER
TRANS AXLE
RESERVOIR
CUTOFF KEY
BEAM LOCK
