Fogco FogCannon HD 160, Руководство пользователя и по обслуживанию

Страница: 8 / 24

Sets the auto oscillation rotation angle (See SET THE ROTATION ANGLE instructions below).
Oscillates the cannon to the right.
Turns the electric valve for zone 2 ON or OFF (1/0) if fitted with Electric Valves.
Turns the timer ON/OFF.
Initiates the system at start up and resets any Alarms.
Lowers the cannon if fitted with Electric Tilt.
Shows the required Service.
Turns the electric valve for zone 3 ON or OFF (1/0) if fitted with Electric Valves.
Sets the Time ON for cycling operation.
Sets the Time OFF for cycling operation.
Changes the Heating System settings (when included) only from Page 2.
Shows the required Service.
Raising and lowering of the cannon and opening and closing of the valves is done manually if the unit
is not equipped with Electric Tilt or Electric Valves.
Manually raise/lower the cannon by loosening the cannon Tilt Handle located on the tilt assembly next to the
main control panel; raise or lower the cannon as needed; tighten the Tilt Handle.
Manually open/close the valves for the individual zones on the crown.
CONFIRM FAN ROTATION
After CONNECTING TO THE APPROPRIATE POWER AND WATER SUPPLIES, verify that the primary
selector switch on the FogCannon is ON. Press the blue button on the control panel and press the F1
button on the keypad. The red Tower light stops flashing and the machine is ready for use
Before using the machine, confirm the correct direction of rotation of the Fan by pressing the Fan
ON/OFF key and verify that it turns counter-clockwise or in the direction of the arrow on the backside
of the cannon. If not, pull the plug from the power source and reverse two of the wires. This should
only be done by a qualified electrician.
SET THE ROTATION ANGLE
It is possible to set a rotation angle anywhere between 0° and 340° where the fogcannon oscillates
automatically.