Foerster HygieneBox Basic, Оригинальное руководство по эксплуатации

Страница: 30 / 47

30 Cleaning
6.1 Cleaning agents
WARNING!
Chemical burns due to the cleaning agents used.
The cleaning agent can cause chemical burns to your eyes or hands.
►
Always wear safety glasses and protective gloves when using cleaning agents. Follow all
the safety instructions listed in the safety data sheet for the cleaning agent and wear the
specified safety equipment.
6.2 Automatic cleaning of the tubes
The suction tube and the 3/2-way valve are automatically cleaned with the cleaning agent.
Cleaning agent is added automatically. You must check each day to ensure that the cleaning
agent containers are full and that the cleaning agents are being dispensed into the mixer of the
automatic feeder.
Note: When feeding fresh milk from an external milk tank, the heat exchanger and the connect-
ing hose from the milk tank to the Combi feeder are not cleaned during automatic hose cleaning.
These components must be cleaned separately via the heat exchanger or manual circuit clean-
ing. Information on frequency and procedure can be found in the
operating instructions for
the automatic feeder. If a SmartTank is connected to your Combi feeder, the heat exchanger
and the connecting hose from the SmartTank to the calf feeder are cleaned automatically.
WARNING!
Chemical burns due to the cleaning agents used.
The cleaning agent can cause chemical burns to your eyes or hands.
►
Always wear safety glasses and protective gloves when using cleaning agents. Follow all
the safety instructions listed in the safety data sheet for the cleaning agent and wear the
specified safety equipment.
The are 2 pre-set automatic tube cleaning cycles.
You set up automatic tube cleaning as follows:
1. Choose > Cleaning in the auto circuit clean sub-menu.
2. In the Cleaning/day menu, you enter the required number of cleaning cycles. You can set
a maximum of 4 cleaning cycles.
Note: You should define at least 1 cleaning cycle per day in order to prevent unhygienic con-
ditions.
3. In det 2 change a. (option), enter if necessary the number of cleaning cycles after which the
automatic feeder should switch to the second cleaning agent. The default setting is 3 clean-
ing cycles.
The lines below show the current count det 2 in x cleaning cycles .