Focusrite clarett octopre, Руководство пользователя

Страница: 15 / 18

15
The setup in this example would allow 18 DAW tracks to be connected to the desk if only a single
Clarett OctoPre was in use.
The above channel counts are applicable at 44.1/48 kHz sample rate, providing that a Clarett 8PreX
is used as the primary interface.
6 . Using Clarett OctoPre’s inserts to record drums
Kick
Compressor
Snare
Compressor
Tom 1
Gate
Tom 2
Gate
Clarett OctoPre
Clock set to Internal via the front panel
Clarett 8Pre
Clock set to ADAT using Focusrite Control
When recording acoustic drums, dynamics control may be applied in various ways to get the sound
you’re after. Compression is frequently added to kick and snare drums to thicken up the sound, while
noise gates are effective on tom-toms to minimise spillage between the various drum mics.
Use looms with a TRS jack on one end wired to two XLRs, TRS jacks or TS jacks as appropriate to
the outboard processors. The “ring” of the TRS jack at the OctoPre end should go to the input of the
processor, the “tip” to the output.