TView Pro AV
User's Manual Rev 2.01
9
2.1 PC Desktop Version
All TView Pro AV Desktop Units will work with IBM PC family computers. Units are shipped with a PC cable, and
Macintosh Adapter. Workstation cables can be ordered.
Follow these steps to install your Desktop TView Pro AV for PC or MAC systems. If you intend to use the TView Pro
AV with Genlock or component output please see Appendix C (Genlock operation) and Appendix D (Component output)
for further information on these features.
1.
Turn the computer off.
2.
Select a convenient location for the TView Pro AV.
3.
Disconnect the Computer Display from the Graphics Card on the Computer .
4.
Connect one end of the PC video cable into the graphics card on the computer (The location from which the
computer display was removed). Connect the other end of the cable into the VGA In connector of the TView Pro AV
5.
Connect the Computer Display to the VGA Out Connector of the TView Pro AV..
6.
Connect your Video Device to the Composite Video and/or S-Video output connector. (You may connect both
outputs simultaneously to the same or different Video Devices: Video is always available on both these outputs.)
7.
Plug the 12 VAC Power Supply's jack into the TView Pro AV’s power input (marked 12-18 VDC, 23W, 2.5 mm).
8.
Plug the 12 VAC Power Supply into an electrical outlet. (If you have a Universal Power Supply, you will have to
supply an appropriate IEC-320 compatible power cord for your country).
9.
Turn the TView Pro AV On.
10.
From the Front Panel or RS-232/422 control, set the Sync Selection to “IN= VGA SYNC”. (See section 3.1.19 for
additional details on Sync Selection.)
11.
Turn the System On. If everything is correctly installed, you will see your computer's normal power up sequence
appearing on both the Computer Display and the Video Device (if the Video Device has a visible display).