Original User Guide | Groove Go Pedelec Version 2
EN-51
Screw fixing
Thread
Tightening torque (Nm)
Pedal crank screw
M6
40
Pedal
9/16
40
Front axle nut
General
25 – 30
Rear axle nut
M12
40
Ahead stem angle adjustment
M6
8 – 10
Ahead stem handlebar clamp
M5 / M6 / M7
M5: 5 / M6: 10 / M7: 14
Ahead stem steerer tube
M5 / M6 / M7
M5: 5 / M6: 10 / M7: 14
Bar end, external clamp
M5 / M6
M5: 5 / M6: 10
Saddle clamp bottom
M5 / M6 / M8
M5: 5 / M6: 10 / M8: 20
Saddle clamp top
M5 / M6 / M7
/ M8
M5: 5.5 / M6: 5.5 / M7: 14 /
M8: 20
Rim brake shoe
M6
10
Sliding drop-outs
M10
16
Disc brake calliper, Shimano, IS and PM
M6
6 – 8
Disc brake calliper, AVID, IS and PM
M6
8 – 10
Disc brake calliper, Magura, IS and PM
M6
6
Gear lever clamp
M5
5
Brake lever clamp
M5
Ref. manufacturer's spec.
Cassette fixing ring
N/A
30 – 40
Screw-on handlebar plugs
M4 / M5
M4: 3 / M5: 5
Luggage rack
M5 / M6
M5: 5 – 6 / M6: 8 – 10
9.3
Battery charger
Display Description
Cause
Remedy
The red
LED flashes
continuously.
There is a
charging fault.
Unplug the charger from the
mains immediately. If the
problem reoccurs, a new battery
charger is required.
10.
Torque settings
DANGER
Only use appropriate tools to tighten screws and bolts. Observe
the specified torque setting. The component manufacturer's torque
settings take precedence (where available). Failure to comply can
result in screws/bolts becoming loose, tearing away or fracturing. If
that happens while you are riding the bike, components may come
off and you could have a severe crash. If screws are overtightened,
components can also be damaged. Tighten all screws and bolts
that are relevant for safety with a torque wrench. This indicates the
corresponding torque in newton metres (Nm).
If no values are shown on the component or component manuals, use the
torque settings from the following table.
