EN-26
Original User Guide | Groove Go Pedelec Version 2
Replacing the rear wheel
1. Attach the chain.
2. Insert the rear wheel centrally in the drop-outs as far as it will go.
If your pedelec has disc brakes, make sure that the brake
disc is placed exactly in the middle between the brake
shoes.
3. Tighten the axle nuts using an 18 mm spanner, turning clockwise and
tighten to a torque of 40 Nm. Make sure that your wheel is correctly
centred.
For 3. Exploded view, motor attachment
Axle nut
Motor
Motor cable
Axle nut
DANGER
If you have released the rim brakes to remove the wheel, you must
close them again, otherwise you will not be able to brake and run the
risk of serious injury.
4. Reinsert the battery.
3.10.1.2 Quick-release wheels
*
DANGER
Quick-release skewer and
brake disk collide
wrong
Front wheel: The quick-release skewer must be
positioned on the opposite side to the brake disc
(where fitted). If the quick-release skewer is on
the same side as the brake disc, there is a risk
that they can clash and lock the front wheel (see
diagram), which can cause a serious accident.
All quick-release systems must be correctly tightened before you set off.
Otherwise the components can loosen – if that happens while riding you
could fall off, resulting in serious injuries.
Removing the front wheel
1. Remove the pedelec battery.
2. Open the quick-release skewer by
swinging the lever by 180˚.
You will now usually be able to see the
word ‘OPEN’ on the inside of the lever.
3. Undo the adjustment nut by turning it
slightly
anticlockwise.
Quick-release skewer
Adjustment nut
For 2. Open the quick-release skewer
*dependent on model
