11
9.0 OPERATING THE APPLIANCE - CONTINUED
©
2019 Focal Point Fires plc.
7
.
Open Window function: (additional hidden functions)
In the thermostat control heating mode, when the ambient temperature drops over 5°C within 10 minutes, the buzzer will
make a "beep" sound three times and the digital display will show E8. This means there is window open or there may exist
some cooling items opened, at the same time the temperature control turns the heating off.
Closing the window or cooling items the ambient temperature will not fall down again and the display E8 disappear.
E8 characters will not disappear if you turn off the heating by the control panel or remote control, even when window is not
closed. You will need to turn the appliance off at the wall and unplug from the power supply.
When the remote control stops operating or its range
seems reduced, it is time to replace the batteries with new
ones.
Remote Control
The fire is supplied with an IR multifunction remote.
Before the remote will operate the plastic insulating sheet needs
to be removed.
Battery Replacement
Battery Requirements: CR2025
1. Locate and remove the battery bracket.
2. The battery has two sides, one with a button feature, and the
other is flat.
3. Insert the battery with the button side down into the battery
bracket, making sure the battery is firmly seated.
Batteries should be removed if the product is to be left unused for a long period of time.
The batteries may contain hazardous substances that could endanger the environment and human health.
This symbol appearing on the battery and/or packaging indicates that used batteries must not be
processed with municipal waste. Instead they should be brought to the appropriate collection point for
recycling.
By correctly disposing of used batteries, you prevent potential negative consequences for the environment
and human health. Recycling used materials also preserves our natural resources.
For more information about collecting and recycling used batteries, please contact your local municipality,
your waste disposal service or the store where you purchased this product.
10.0 SAFETY CUT-OUT SYSTEM
NOTE: The LED display panel will remain operational if the cut-out is activated, only the fan heater elements are prevented
from operating.
This product has one non-self-resetting overheat protection device (thermal cut-out) which will activate if the air inlets or outlets
are obstructed. For safety reasons the fire will NOT switch on again automatically, the following procedure must be carried out
before the fire can be operated.
NOTE: The visual effect will remain operational if the cutout is activated, only the fan heater is prevented from working.
Switch OFF the appliance at the wall socket or outlet. Leave the fire OFF for a period of no less than 10 minutes, ensuring all
obstructions are removed. Switch the appliance ON at the wall. Ensure the appliance is turned ON at the control switches. If
the fire fails to operate correctly, repeat the above procedure. If an attempt to switch on the appliance is made before the safety
cutout has reset, the appliance may cutout for a further period of time. If the sequence has been followed correctly and the
appliance still fails to function, check the fuse in the wall outlet. If this is not the cause, call an electrician or maintenance engineer.
GB IE
11.0 CLEANING AND MAINTENANCE
ALWAYS DISCONNECT THE APPLIANCE FROM THE MAINS SUPPLY OUTLET
SOCKET BEFORE UNDERTAKING ANY CLEANING OR MAINTENANCE!
For general cleaning use a soft clean duster - never use harsh abrasive or cleaners. The glass viewing screen should be cleaned
carefully with a soft cloth.
If in doubt consult a qualified electrician. Refer to Section 3.0 Appliance Data for fuse specification. Excluding fuses, use only
genuine manufacturers spare parts available from your supplier.
Replacing the remote control battery:
When the battery becomes weak, the range of the remote control becomes shorter. Replace the battery with a new CR2025
lithium battery.
Note: Keep the lithium battery out of the reach of children.
