41101-0-0919
Page 1
Empire Comfort Systems Inc. • Belleville, IL
For Use on: GWT35W(nATUrAL, propAne), hWGW350(nATUrAL, propAne)
41052 - venT sAFeTy sWiTch reLocATion kiT
WArninG
This conversion kit is to be installed by an Empire Comfort Systems, Inc. dealer (or other qualified
agency1)* in accordance with the manufacturer’s instructions and all codes and requirements
of the authority having jurisdiction. Failure to follow instructions could result in serious injury
or property damage. The qualified agency performing this work assumes responsibility for this
conversion.
1 national Fuel Gas code Z223.1 (Latest edition), natural Gas and propane installation code,
csA B149.1
*The term “qualified agency” means any individual, firm, corporation or company which either in
person or through a representative is engaged in and is responsible for (a) the installation of gas
piping or (b) the connection, installation repair, or servicing of equipment, who is experienced
in such work, familiar with all precautions required, and has complied with all the requirements
of the authority having jurisdiction.
Tools required:
•
Phillips Screw Driver
•
1/4-Inch Nut Driver
•
Drill (Optional)
•
5/16-Inch Nut Driver
•
1/8-Inch Drill Bit (Optional)
relocation instructions
1. Remove blower (if installed)
by lifting off 2 mounting
screws and set aside.
2. Remove 3 screws from the
top of heater and 2 screws
from the lower front.
see Figure 1.
3. Remove front casing.
insTALLATion insTrUcTions
sWiTch reLocATion kiT
Figure 1
