FUEL BED LAYOUT
This fire is supplied with 11 ceramic coals. The coals may vary slightly in size, shape, in order to allow a realistic
layout.
Firstly, remove the ceramic compnents from their
protective packaging, and place the brick panel against the
rear of the firebox
Place the ceramic combustion matrix onto the burner.
Place the front row of five coals on to the matrix. Ensure the
coals are firmly against the side cheeks as shown in the
photograph. If necessary, pull the coals forward slightly to
ensure their rear edges do not overhang the flame ports. The
edges of the coals MUST NOT be allowed to enter the flame
ports.
Place the middle row of four coals onto the supports in the
matrix, over the top of the holes. Ensure the coals are not
turned sideways, such that they actually enter the holes.
Finally, place the rear row of two coals.
Note: The coals must not be crammed together, or inserted
into the holes in the matrix. A well laid out, generously
spaced coal layout will give the best results.
The coals may be rotated slightly within their positions to give a good visual effect. Pay special attention to finally
adjust the coals with the fire lit on the HIGH setting in order to ensure that no flames play onto the firebox sides.
This will reduce the possiblity of heat discolouration.
The fire is designed to operate correctly with the coals supplied when assembled according to the instructions.
Never add to the eleven coals, or change them for a different type. Never throw rubbish or other matter onto the
fuelbed.
9
9.0
