Focal Point Elysee Fanflue, Инструкция по установке, обслуживанию и эксплуатации

Страница: 14 / 24

FITTING THE FAN TERMINAL (continued)
Fitting the fan terminal by recessing into the outer wall
If already fitted in the fan box, remove the four long M4 screws from the top and bottom of the fan terminal. Fit
the terminal into the wall opening previously prepared, ensuring the flue tube seats correctly over the terminal
spigot. When correctly fitted, insert the four screws into the threaded inserts fitted to the inside of the top and
bottom of the terminal. Using a suitable screwdriver, continue to wind in the four screws from the inside of the
box until the fan terminal is held securely in the opening. Alternatively, four holes may be marked in the sides of
the fan terminal, and these drilled through into the brick work. The terminal can then be secured with rawl plugs
and screws. Apply a bead of silicone weather sealant, or similar suitable sealant around the top and side edges
of the frame to provide a good seal to the wall, eliminating water ingress.
Note: The recessed fan terminal MUST NOT be cemented into place within the outer wall.
With the terminal fixed into position the wires may now be connected. Attach the green earth wire to the screw
securing the fan earth wire. Fit the two three way connector to the relevant connectors from the fan unit and
pressure switch. Check that none of the wires can come into contact with hot surfaces or moving parts of the
fan. Use the cable tie supplied to secure the wires to the terminal. With all the cables properly connected, fit the
terminal cover ensuring the fan outlet is clear, and secure with the four screws provided. Offer the wire terminal
guard cage into position, mark and drill the relevant mounting holes, and secure into place using rawl plugs and
screws. The terminal guard should be fitted at all times to comply with any Byelaws in force.
Schematic wiring of fan unit
12
Terminal surface mounted onto outside wall
Terminal recessed into outside wall
Seal along top and sides of terminal
Seal around the top and sides of frame
Fan
Pressure Switch
Thermal Switch
Earth
Three-way connectors
To appliance
BLACK
YELLOW
RED
8.8
Screw
outward
s to
secure
fan box
into wall
aperture